Back to Table of Contents

3.4. Making cutters' imposition

Performing imposition of die cutters and graphics matching them should be divided into two stages:

1. Imposition of the die cutter: we recommend that all additional elements are turned off during the imposition of the die cutter. A sheet with an impositioned cutter (excluding sheets with impositioned graphics) can be performed using the command: Start an imposition of the active sheet.
2. Graphic’s imposition: by impositioning the graphics, you need to turn on all the elements needed for correct printing process (marks, calibration strips etc.).

Turning on: SHOW DIE CUT: YES will let you control matching graphics to the impositioned cutter.